[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <CAGcw5iQ6qfqgMuWhg8arL4e1n1w71JoAZyPBY4_MZ_wP++_sHg@mail.gmail.com>
Date: Fri, 7 Jun 2013 07:33:25 +0200
From: Marc Brinkmann <marc.brinkmann@...il.com>
To: john-users@...ts.openwall.com
Subject: Re: Adding more "Nodes" to MPI Session
Hmm, maybe i was a bit to optimistic.
Also my questions are no more directly related to John, but git, i'll ask
them.
During Breakfast i tried to switch the branch, but i run into some trouble.
I don't use any other git-project, or any other SCM software, so i'm very
unexperienced here.
I just googled, how to branch / to switch to bleeding-jumbo.
located in JohnTheRipper-folder i ran
$ git branch bleeding-jumbo
$ git pull -> not sure anymore, i think some files were downloaded.
$ cd src/
$ make clean linux-x86-64-opencl -> format doesn't exist.
$ make -> there is no native, nor opencl, and if i compile
$ make clean linux-x86-64 and then
$ cd ../run
$ ./john --test --format=[office/office2010] if fails (i didn't run exactly
this command, i just want to show i run office and office2010 :) )
If i just
$ ./john --test it check very few formats, according to what i knew from my
open-cl build
I think i tried something more with checkout and branch, to return to my
previous ... setup, but i failed.
So i deleted the John folder and cloned it once again.
So my question is, how would i change to bleeding-jumbo branch so that i
can use break an office2010 password? thanks again =)
BR Marc
2013/6/7 Marc Brinkmann <marc.brinkmann@...il.com>
> Thank you both very much.
> It works flawlessly, as you discribed :)
>
>
> 2013/6/7 magnum <john.magnum@...hmail.com>
>
>> On 6 Jun, 2013, at 21:05 , Dhiru Kholia <dhiru.kholia@...il.com> wrote:
>> > On Fri, Jun 7, 2013 at 12:25 AM, Marc Brinkmann
>> > <marc.brinkmann@...il.com> wrote:
>> >> Right now, i run mpiexec /home/marc/John/run/john -- (command)
>> >> What is the command to "use" OMP?
>> >
>> > /home/marc/John/run/john -- (command)
>> >
>> > No special command is needed to use OMP ;)
>>
>> Right. Except when running under MPI, the defaults will turn OMP off so
>> you'll have to change john.conf MPIOMPMutex like I already described.
>>
>> magnum
>>
>
>
Powered by blists - more mailing lists
Confused about mailing lists and their use?
Read about mailing lists on Wikipedia
and check out these
guidelines on proper formatting of your messages.
